ASTM D 4307-1999 作为分析标准的液体掺混物制备的标准操作规程

上一篇: ASTM D 3012-1999 用双轴旋转器测定丙烯塑料的热氧化稳定性的试验方法
下一篇: ASTM D 644-1999 用炉烘干法测定纸和纸板中水分的标准试验方法

Product Code:SAE J2337/2
Title:Connections for Fluid Power and High Pressure Use - Ports, Stud Ends, and Plugs With Iso 261 Threads and O-Rings Sealing - Part 2: Stud End Requirements, Dimensions, Design and Test Methods
Issuing Committee:Hydraulic Tube Fittings Committee
Scope:PurposeThis part of SAE J2337 specifies dimensions, design, and performance requirements for eight connectors using a conical seal to insure leak proof performance with a design factor of 4 to 1.Field of ApplicationThese connectors are intended for general and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to the working pressures shown in Table 1. Since many factors influence the pressure at which hydraulic systems will or will not perform satisfactorily, these values should not be construed as guaranteed minimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to ensure that the required performance levels are met.For use of these connectors in conditions outside the pressure and temperature limits specified, contact the manufacturer.【英文标准名称】:StandardSpecificationforPolytetrafluoroethylene-(PTFE)CoatedGlassFabric
【原文标准名称】:聚四氟乙烯(PTFE)涂覆玻璃织物的标准规范
【标准号】:ASTMD4969-2007
【标准状态】:现行
【国别】:美国
【发布日期】:2007
【实施或试行日期】:
【发布单位】:美国材料与试验协会(ASTM)
【起草单位】:ASTM
【标准类型】:()
【标准水平】:()
【中文主题词】:涂层;玻璃织物;聚四氟乙烯
【英文主题词】:Coatings;Glassfabrics;Polytetrafluoroethylene
【摘要】:
【中国标准分类号】:Q36
【国际标准分类号】:59_080_40
【页数】:4P;A4
【正文语种】:英语